Chimney Chase

Chimney Chase Cover Replacement and Top Flashing in Issaquah, WA

A factory-built chimney chase whose metal cover had rusted through and was running water down the siding. Replaced with a stainless cover and a sealed collar, so the top of the chase sheds water instead of holding it.

Project Details

Issaquah, WA
Single-Family Residential
Chimney Chase Cover Replacement & Top Flashing
2026

READY TO SOLVE THE FULL PROBLEM?

Get an Estimate

Tell us about your project and we’ll get back to you within the hour.

Why It Matters

Every Service Starts With the Full Picture.

A chase is the framed, sided box that encloses a factory-built flue, and the cover is the lid on top of it. It is usually the first part to fail. Most chases are finished with a flat galvanised lid that has no slope to drain it and no overhang to throw water clear of the walls below, so rain stands on the metal until it rusts through. The rust streaks running down the chase in the first photo are the visible stage of that: by the time staining shows on the outside, water has been getting into the framing inside the chase for some time.

The Solution

A Full-System Repair, Done Once.

Painting or sealing a cover that has already perforated is a seasonal repair – sealant over rust lifts, and the water finds the same hole again. The cover was replaced outright. A chase cover is only doing its job when it is stainless rather than bare galvanised, shaped so water runs to the edges instead of ponding in the middle, and sized to overhang the chase so runoff is thrown clear of the siding rather than tracked down it. The collar where the flue passes through has to be sealed to the pipe itself, because that joint is the other half of the leak. Chase work and flashing at the top line are one job here, not two.

Scope of Work

What We Did.

The failed cover came off and a new stainless chase cover went on in its place, with an overhang past the chase face and a sealed collar at the flue penetration. A rain cap was fitted over the open flue, and the chase itself was made good and refinished so the new top line is clean. The second photo is the finished top, shot from the same position as the first.

Chimneyz works throughout Issaquah, WA and the surrounding area.

Results

Before & After.

See the difference a full-system repair makes — from failing masonry and corroded flashing to a fully restored, watertight chimney.

Factory-built chimney chase with a rusted-through sheet metal cover and water staining down the chase siding
The same chimney chase after a new stainless steel chase cover, storm collar and rain cap were fitted

Project Gallery

A Closer Look at the Work.

READY TO SOLVE THE FULL PROBLEM?

Get a Clear Inspection and the Right Repair Plan.

From chimney leaks and failing masonry to roofline issues and interior damage, Chimneyz helps homeowners identify the real source of the problem and fix it with one coordinated solution.

Technician repairing brick chimney crown

More Projects

Similar Work We've Completed.

Rusted steel firebox and the masonry behind it exposed after the surrounding wall was opened to the studs for removal

Interior Fireplace and Firebox Removal in Everett, WA

Everett, WA

Direct-vent fireplace set on its platform in open framing, with the vent pipe running up through the floor above and warm-air ducts to either side

Fireplace Installation in New Construction, Bothell, WA

Bothell, WA

Rebuilt brick chimney with a new cast crown, two black rain caps and new black base flashing

Two-Flue Chimney Rebuild with a Cast Crown in Snohomish, WA

Snohomish, WA

Completed brick chimney rebuild on a craftsman home with a new crown, rain cap and base flashing

Chimney Rebuild with a New Clay Flue Liner in Seattle, WA

Seattle, WA

CALL NOW