Chimney Crown

Chimney Crown Recast and Rain Caps in Shoreline, WA

A wide brick chimney on a flat roof, with a cracked and moss-covered crown and two flues left open to the weather. Recast with a proper overhang, capped on both flues, and reflashed where it meets the roof.

Project Details

Shoreline, WA
Single-Family Residential
Chimney Crown Recast, Rain Caps & Base Flashing
2026

READY TO SOLVE THE FULL PROBLEM?

Get an Estimate

Tell us about your project and we’ll get back to you within the hour.

Why It Matters

Every Service Starts With the Full Picture.

The crown is the sloped slab across the top of a chimney, and its only job is to throw rain clear of the brick underneath it. The crown in the first photo had cracked through and lost its slope, so instead of shedding water it was holding it – which is why there is moss growing on it. Both flues were also open. An uncapped flue takes rain straight down the inside of the chimney, where it does its damage out of sight, and on a flat roof there is no pitch to carry that water away from the base either.

The Solution

A Full-System Repair, Done Once.

Sealing a cracked crown buys a season. A recast removes the failed slab and casts a new one in place, with a genuine overhang past the brick face and a drip edge cut into its underside so water breaks off instead of tracking back along the soffit and down the masonry. Caps go on at the same time, because a new crown still leaves the flue itself open, and the base flashing is renewed with it – on a flat roof that junction has nowhere to drain to, so it has to be right.

Scope of Work

What We Did.

The failed crown came off and a new one was cast in place with an overhang. Stainless rain caps were fitted to both flues, and new flashing was run where the chimney meets the flat roof. The second photo is the finished top from the same corner.

Chimneyz works throughout Shoreline, WA and the surrounding area.

Results

Before & After.

See the difference a full-system repair makes — from failing masonry and corroded flashing to a fully restored, watertight chimney.

Wide brick chimney on a flat roof with a cracked, moss-covered crown and uncapped flues
The same flat-roof chimney after a new cast crown, two stainless rain caps and new base flashing

Project Gallery

A Closer Look at the Work.

READY TO SOLVE THE FULL PROBLEM?

Get a Clear Inspection and the Right Repair Plan.

From chimney leaks and failing masonry to roofline issues and interior damage, Chimneyz helps homeowners identify the real source of the problem and fix it with one coordinated solution.

Technician repairing brick chimney crown

More Projects

Similar Work We've Completed.

Rusted steel firebox and the masonry behind it exposed after the surrounding wall was opened to the studs for removal

Interior Fireplace and Firebox Removal in Everett, WA

Everett, WA

Direct-vent fireplace set on its platform in open framing, with the vent pipe running up through the floor above and warm-air ducts to either side

Fireplace Installation in New Construction, Bothell, WA

Bothell, WA

Rebuilt brick chimney with a new cast crown, two black rain caps and new black base flashing

Two-Flue Chimney Rebuild with a Cast Crown in Snohomish, WA

Snohomish, WA

Completed brick chimney rebuild on a craftsman home with a new crown, rain cap and base flashing

Chimney Rebuild with a New Clay Flue Liner in Seattle, WA

Seattle, WA

CALL NOW