Chimney Rebuild

Chimney Rebuild Above the Roofline in Kirkland, WA

The masonry above the roofline had gone soft – mortar washed out of the joints, brick faces spalling away, moss holding water against the top courses. Rebuilt from the roofline up, with a new crown, a rain cap and new base flashing.

Project Details

Kirkland, WA
Single-Family Residential
Above-Roofline Chimney Rebuild, Crown & Base Flashing
2026

READY TO SOLVE THE FULL PROBLEM?

Get an Estimate

Tell us about your project and we’ll get back to you within the hour.

Why It Matters

Every Service Starts With the Full Picture.

The part of a chimney that fails first is almost always the part above the roofline, and for a simple reason: it is the only masonry on the house exposed on all four sides with nothing over it. In this climate it takes rain from every direction, never fully dries, and cycles through freezing while it is still saturated. The first photo shows the whole sequence in one frame – moss across the top courses holding moisture against the brick, mortar joints eroded back, and brick faces spalled off where water got in behind them and froze.

The Solution

A Full-System Repair, Done Once.

Once the faces are spalling, repointing does not solve it. New mortar needs sound brick either side of the joint to bond to, and brick that has lost its face keeps taking on water. The masonry above the roof was taken down and rebuilt instead, and the top finished with a cast crown that overhangs the brick so runoff is thrown clear of the faces below rather than running down them. The base flashing was renewed in the same visit, because a rebuilt stack sitting on old flashing just moves the leak down a few feet. Rebuilding the stack, recasting the crown and renewing the flashing are one scope of work.

Scope of Work

What We Did.

Masonry above the roofline taken down and rebuilt, a new cast crown with an overhang, a rain cap over the flue, and new black base flashing where the chimney meets the roof. The second photo is the finished stack from the same roof position.

Chimneyz works throughout Kirkland, WA and the surrounding area.

Results

Before & After.

See the difference a full-system repair makes — from failing masonry and corroded flashing to a fully restored, watertight chimney.

Chimney above the roofline with moss, spalled brick faces and an eroded concrete cap before rebuilding
The same chimney rebuilt above the roofline with a new cast crown, rain cap and black base flashing

Project Gallery

A Closer Look at the Work.

READY TO SOLVE THE FULL PROBLEM?

Get a Clear Inspection and the Right Repair Plan.

From chimney leaks and failing masonry to roofline issues and interior damage, Chimneyz helps homeowners identify the real source of the problem and fix it with one coordinated solution.

Technician repairing brick chimney crown

More Projects

Similar Work We've Completed.

Rusted steel firebox and the masonry behind it exposed after the surrounding wall was opened to the studs for removal

Interior Fireplace and Firebox Removal in Everett, WA

Everett, WA

Direct-vent fireplace set on its platform in open framing, with the vent pipe running up through the floor above and warm-air ducts to either side

Fireplace Installation in New Construction, Bothell, WA

Bothell, WA

Rebuilt brick chimney with a new cast crown, two black rain caps and new black base flashing

Two-Flue Chimney Rebuild with a Cast Crown in Snohomish, WA

Snohomish, WA

Completed brick chimney rebuild on a craftsman home with a new crown, rain cap and base flashing

Chimney Rebuild with a New Clay Flue Liner in Seattle, WA

Seattle, WA

CALL NOW